Why change your final drive?

Two reasons to change a final drive: a ratio that matches the car and the circuit, and the strength a motorsport crown wheel and pinion adds over the OEM part.

There are two common reasons to change a final drive. On a car that still has its OEM final drive, the reason is usually strength and service life. On a car that already has a motorsport final drive, it is usually the ratio: matching the gearing to the car and the circuit. This article covers both.

What the final drive is

Besides the gears in the gearbox, there is one more gear pair in the driveline, in the differential. It is known as the final drive, the crown wheel and pinion (CWP) or the ring and pinion. Its ratio multiplies every gear in the gearbox by the same factor.

The crown wheel in an opened differential housing.

Choosing the ratio

Gearing is always a compromise. A numerically lower (taller) final drive ratio gives a higher speed in each gear. A numerically higher (shorter) ratio gives more torque at the wheels and therefore stronger acceleration, at the cost of speed in each gear.

The table shows the effect for one example: a BMW E92 with a six-speed DG400 gearbox, a maximum engine speed of 8,000 rpm and a wheel radius of 311.5 mm. The gearbox ratios are 2.84, 2.13, 1.76, 1.50, 1.28 and 1.13. The speeds are the calculated speeds at 8,000 rpm in each gear, in km/h.

Gear Final drive 4.10 Final drive 4.75 Final drive 5.28
1st 81 70 63
2nd 108 93 84
3rd 130 112 101
4th 153 132 119
5th 179 155 139
6th 203 175 158
Torque at the wheels Reference +15.8% +28.7%

Going from 4.10 to 5.28 lowers the speed at maximum rpm in sixth gear from 203 km/h to 158 km/h, while the torque at the wheels in every gear rises by 28.7%. Torque is traded for top speed, or top speed for torque. The appropriate ratio is the one that lets the car use its gears over the speed range of the circuit it runs on.

Why a motorsport final drive

An OEM final drive is designed for the specification of the car it was built for. When the car is developed further or the engine output is raised, the standard driveline parts run a higher risk of failure. The driveline is only as strong as its weakest part, so the final drive has to be upgraded along with the rest.

Characteristics of a motorsport final drive:

The KMP final drives and the complete differential units built with them are listed under Differentials. For a ratio or an application that is not listed, contact KMP with the details of the car and the gearbox.

All tech articles